Differences

This shows you the differences between two versions of the page.

--- amc:ss2024:home_assistant_server:start [2024/07/31 00:43] – [3. Set up] ekaterina.zakharova
+++ amc:ss2024:home_assistant_server:start [2024/07/31 02:42] (current) – [3)MQTT setup] ekaterina.zakharova
@@ Line 95: / Line 95: @@
   (with Pet Feeder(Tuya), Tuya  lamp, Zigbee Motion + Temperature sensors as components of the system)
-     ==== Installation of Home Assistant on Raspberry Pi ====
+==== 1)Installation of Home Assistant on Raspberry Pi ====
@@ Line 102: / Line 102: @@
   * Credits go to Taycan.
-==== Pet feeder + Zigbee motion sensor ====
+==== 2)Wifi AP integration ====
-  * connected using the **{{ https://nodered.org/|Node Red tool}}**
+  - In HA settings, select "Automatic" on both IPv4 & IPv6
+  - Connect to your Wifi Access point
+<imgcaption label|Network configuration>{{:amc:ss2024:home_assistant_server:wlan_1_.jpg?700|Network configuration}}</imgcaption>
+==== 3)MQTT setup ====
+  - Go to "Settings"->Add-ons->Add-on store->Find the "Mosquito broker" add-on and click it->Click "Install"
+  - <imgcaption label|Mosquitto Add-on>{{:amc:ss2024:home_assistant_server:mqtt.jpg?700|}}</imgcaption>
+  ***How to use.** The add-on has a couple of options available.
+ //To get the add-on running://
+  - Start the add-on.
+  - Have some patience and wait a couple of minutes.
+  - Check the add-on log output to see the result.
+//Create a new user for MQTT via your Home Assistant's frontend// **Settings -> People -> Users**, (i.e. not on Mosquitto's Configuration tab).
+//''Notes:''//
+  - This name cannot be homeassistant or addons, those are reserved usernames.
+  - If you do not see the option to create a new user, ensure that Advanced Mode is enabled in your Home Assistant profile.
+     * To use the Mosquitto as a broker go to the integration page and install the configuration with one click:
+       - Navigate in your Home Assistant frontend to **Settings** -> **Devices & Services** -> **Integrations**.MQTT should appear as a discovered integration at the top of the page.
+       - Select it and check the box to enable MQTT discovery if desired, and hit submit.
+       - If you have old MQTT settings available, remove this old integration and restart Home Assistant to see the new one.
+**Node-RED & INfluxDB & Local Tuya are installed in a similar to MQTT fashion **
+----
@@ Line 114: / Line 148: @@
-----
 ===== 4. Tuya devices: pet feeder, lamp =====