HSRW EOLab Students Wiki

User Tools

Site Tools

Trace: • soil_sampler • gfl • groupe • notes
amc2022:groupd:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

amc2022:groupd:start [2022/09/11 12:53] – [2.8 Software Packages] adiel001amc2022:groupd:start [2023/01/05 14:38] (current) – external edit 127.0.0.1
Line 235: Line 235:
 We start with a testing phase of the materials, debugging and selecting fitting components followed by the execution of the project goal; a prototype for building optimization of heat and lighting use.  We start with a testing phase of the materials, debugging and selecting fitting components followed by the execution of the project goal; a prototype for building optimization of heat and lighting use. 
  
-Later on in the project development, the group became split geographically, coordinating efforts between Barbados and Germany. As a result, some variance of  components  are used (eg. an SHT module in place of the DHT sensor, relay modules), as a means of meeting the project execution. In end effect the project design was improved. The duplicity of components allowed us to work remotely and  cooperatively, through core stages of the project.+Later on in the project development, the group became split geographically, coordinating efforts between Barbados and Germany. As a result, some variance of  components  are used (eg. an SHT module in place of the DHT sensor, relay modules), as a means of meeting the project targets. In end effect the project design was improved. The duplicity of components allowed us to work remotely and  cooperatively, through core stages of the project.
  
  
Line 245: Line 245:
  
 ==== 4.1 LDR Photoresistor x Arduino UNO ==== ==== 4.1 LDR Photoresistor x Arduino UNO ====
 +
 //Batson// \\ //Batson// \\
-For the Setup, a 10k Ohm resistor was paired to the resistor on a breadboard fed by arduino UNO. It was found that the components were working responsively. To demonstrate the on and off cycle of a lightulb or lighting system 2 LEDS were used with 220 Ohm resitors each.+ 
 +For the Setup, a 10k Ohm resistor was paired to the resistor on a breadboard fed by Arduino UNO. It was found that the components were working responsively. To demonstrate the on and off cycle of a lightbulb or lighting system 2 LEDS were used with 220 Ohm resistors each.
  
 ---- ----
 ** 4.1.1 Schematic** ** 4.1.1 Schematic**
 +
 //Batson// \\ //Batson// \\
 ---- ----
amc2022/groupd/start.1662893608.txt.gz · Last modified: 2023/01/05 14:38 (external edit)