Differences

This shows you the differences between two versions of the page.

--- emrp:ws2025:agv [2026/02/27 04:57] – [4.5.2 Automations] 23553_students.hsrw
+++ emrp:ws2025:agv [2026/02/27 17:48] (current) – [4.3 Enclosure, Sensor and Fan placement] 23553_students.hsrw
@@ Line 250: / Line 250: @@
 </imgcaption>
-Because the electronics enclosure is mounted on the greenhouse door while the Ethernet feed and the inside sensor cable are routed to fixed points, both cables are installed with sufficient slack to accommodate the door movement without putting strain on connectors or wiring.
+The electronics enclosure is installed next to the greenhouse door (rather than on the door itself) and remains stationary. The Ethernet feed and the DHT11 sensors are therefore routed to this fixed mounting point, while only the fan wiring requires sufficient slack to accommodate the door’s movement without putting strain on the connectors or cables.
 ==== 4.4 Software setup ====