opensleep:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
opensleep:start [2021/01/29 17:18] – henrik001 | opensleep:start [2023/01/05 14:38] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 5: | Line 5: | ||
====Hardware==== | ====Hardware==== | ||
- | Since the original hardware is outdated I used an ESP32 microcontroller instead. The Heartrate sensor used in the original project did not work for me, so I ordered a MAX30102 sensor that is connected to the esp via i2c. It works better than the old one, although it is sometimes difficult to find a good position and the right amount of pressure for it to work. The flex sensor works perfectly fine. Because of the modified hardware, I wrote a new script for the esp32 based on a ble example. I attached the hardware with flexible tape to a microfiber glove from real. It's a little bit hard to get into but it is quite comfortable to wear. | + | Since the original hardware is outdated I used an ESP32 microcontroller instead. The Heartrate sensor used in the original project did not work for me, so I ordered a MAX30102 sensor that is connected to the esp via i2c. It works better than the old one, although it is sometimes difficult to find a good position and the right amount of pressure for it to work. The flex sensor works perfectly fine. Because of the modified hardware, I wrote a new script for the esp32 based on a Bluetooth Low Energy |
+ | < | ||
< | < | ||
Line 20: | Line 21: | ||
< | < | ||
- | < | + | |
Line 26: | Line 27: | ||
====Software==== | ====Software==== | ||
- | For the software, I used the dormio web application made by [[https:// | + | For the software, I used the [[https:// |
opensleep/start.1611937122.txt.gz · Last modified: 2023/01/05 14:38 (external edit)