Differences

This shows you the differences between two versions of the page.

--- soil_sampler:tests [2021/04/21 12:13] – jeff001
+++ soil_sampler:tests [2023/01/05 14:38] (current) – external edit 127.0.0.1
@@ Line 3: / Line 3: @@
 ===== Drilling =====
-====Test1====
 Place: GreenFabLab, KampLintfort, Germany.\\
@@ Line 9: / Line 8: @@
 This test was made to check the behavior of a drill to get familiar with the process and consider it for machine structure requirements.
+Soil type: Clayey
 **Materials:**
@@ Line 16: / Line 16: @@
 - Torque: 21/55Nm
-. Bit:\\
+. Drill bit:\\
 - Diameter: 32mm\\
 - Length: 500mm
@@ Line 24: / Line 24: @@
 **Process:**
-The first time, I got to drill 30cm depth.
+The first time, I got to drill 30cm depth.\\
 {{:soil_sampler:Test1_2.jpg?450|}}
-The second time, I got to drill 50cm, which is the total length of the bit.
+The second time, I got to drill 50cm, which is the total length of the bit.\\
+{{:soil_sampler:Test1_1.jpg?450|}}
-{{:soil_sampler:Test1_1.jpg?450|}}
+**Outlook:**
-**Results:**
+During this test, it was remarkable that [with this amount of torque and these soil conditions] it is not possible to take a soil sample by drilling more than 30 centimeters deep in one go, separate the total depth on multiple phases would be a good an alternative to increasing torque in this case.
-From this test, I observed that it can not take the soil sample by drilling in one go, separate the total depth on multiple phases would be the best in this case.
+<!--Measuring the torque in every moment, then when the torque demanded increases, finish that phase, clean the bit and continue with the next one.-->